|
|
Form
|
Stereo
Integrated Amplifier |
|
Output power
(Both channel drive, 20Hz - 20kHz) |
120W+120W (4
ohm, 0.008%)
100W+100W (6 ohm, 0.005%)
90W+90W (8 ohm, 0.005%) |
|
Input
sensitivity/impedance |
Phono man month:
2.5mV / 50kohm
Phono MC: 0.2mV/100 ohms
compact disk, Tuner, Line, Tape:150mV /, 50kohm |
|
Maximum
permissible input (1kHz, 0.008%) |
Phono MM:200mV
Phono MC:19mV |
|
Frequency
characteristic |
Phono man month:
20Hz-20kHz±0.2dB
Phono MC: 20Hz-20kHz±0.3dB
compact disk, Tuner, Line, and Tape:1Hz-150kHz+0 -3 dB |
|
S/N ratio (IHF,
A network)
Short circuit |
Phono man month:
89dB (2.5mV o'clock)
Phono MC: 71dB (0.25mV o'clock)
compact disk, Tuner, Line, DAT/Tape1, 2:108dB |
|
Supply voltage
|
AC100V,
50Hz/60Hz |
|
AC outlet
|
Power-switch
interlock: Two lines (150W)
Power-switch un-interlocking.: One line (100W) |
|
Power
consumption (Electrical Appliance and Material Control Law)
|
220W
|
|
Dimensions
|
Width 420x
height 162x depth of 435mm |
|
Weight
|
14.4kg
|
Shortest-izing of a
signal path, no vibrating and absent-resonance-izing, the stereo
Integrated Amplifier that aimed at the improvement in the drive capacity
of the speaker at the time of a low load intensity.
Shortest-ization of leading about of a signal path is attained in input
block. Moreover, if a source direct switchpoint is turned ON, a volume
and power amplifier link directly and a purer sound can be enjoyed.
And in the power amplifier block, it arranged along with the fluence of
a signal and distance from a power-source part is shortest-ized.
Moreover, in the speaker selector block, a relay substrate and a speaker
termination are linked directly and excessive leading about is reduced.
While rigidity has adopted everywhere the honeycomb form where it
excelled in periodic damping highly and distributes and decreases an
oscillation in the many orientations, the oscillating distorted noise is
low stopped by making it high-rigidity-ize.
Moreover, the heat-dissipation effect excellent in considering it as a
chimney type honeycomb heat sink has also been acquired.
Furthermore, the oscillation from the outside is suppressed by adopting
honeycomb structure also as an insulator.
It was considered as the balance structure which lessened the mechanical
stress of the volume main unit, and the floating structure for
suppressing the influence of an oscillation to a min is adopted as a
volume.
The non switching circuit TypeII which expanded the area of switching
distorted zero further is adopted.
This has improved the nonlinearity of thermal distortion or an output
stage greatly.
The NF-CR type is adopted as a Phono equalizer.
In order to prevent a break-in of power-source line noise, the
oxygen-free-high-conductivity-copper very-thick power cord of a polar
attached indicator is adopted.
The speaker terminal of the vice type which performs a current supply
source with few losses is adopted.
The fuse for audios focused on a tone quality, the rotary knob of
aluminum Naked material shaving appearance, etc. are adopted.
http://www.reviewcentre.com/reviews3264.html
|
