SCHEDE E RECENSIONI

Nad 2400 - 2700

Ampli finale

SCHEDA

Di cosa si tratta:

Ampli Finale


L'importanza di iscrivervi alla newsletter

Produttore:

Nad

Caratteristiche:

100 watt

Costo 2400 :

1.370.000 lire anno  1995

Costo 2700 : 1.370.000 lire anno  1995

 Info:

www.nad.com

Vasta Gamma di Nuovo Usato disponibili  Click

CARATTERISTICHE

 

 

 

SCHEDA FOTOGRAFICA

2400

2700

 

VEDIAMO DIETRO

2400

2700

 

VEDIAMO DENTRO

 

 

MANUALE

 

 

DESCRIZIONE

 

The NAD 2400 is a stereo power amplifier that is sure to boost the performance of your audio system. With an RMS power handling of 100 watts per channel, this NAD amplifier makes sure that you experience a power-packed performance. The 3 Hz – 100 kHz frequency response range of this stereo power amplifier provides you with crisp highs and a tight bass response. Thanks to the signal-to-noise ratio of 118 dB, this NAD amplifier reproduces even the minutest of musical detail. The input, driver, and output stages of the NAD 2400 are individually decoupled from the power supply, thus preventing supply-modulation distortion, resulting in a clear output.

 

While its Power Envelope circuitry produces 370 to 440 watts channel of tone-burst power for music.

 

The high-current output stage of the 2400 delivers peak currents up to 40 amperes for precise control of voice-coil motion with speaker impedances as low as 2 ohms. In bridged mono operation the 2400 produces over 2OO watts of steady-state power and over 800 watts of dynamic tone-burst power.

 

To enable the user to make the fullest use of the available power, a warning light illuminates if the amplifier is over-driven into distortion or exhibits any deviation from linearity. A high-precision circuit continually compares the input and output signals and flashes the LED if a potentially audible difference is detected. Each stage of the amplifier (input, driver, and output) is individually decoupled from the power supply to prevent the dynamic supply-modulation distortion that causes some amplifiers to sound “veiled” and muddy.

 

POWER AMP SECTION, Continuous output power into 8 ohm* 100W (20dBW) Rated distortion (THD 20Hz - 20kHz) 0.03% Clipping power (maximum continuous power per channel) 130W IHF Dynamic headroom at 8 ohm+5.7dB IHF dynamic power (maximum short term power per channel) 8ohm 370W (25.7dBW) 4ohm 400W (26dBW) Damping factor (ref. 8˝, 50Hz) >100 Input impedance 20k˝ / 600pF Input sensitivity (for rated power into 8˝) 1V

 

 Frequency response 3Hz - 100kHz / +0, -3dBdB Signal/noise ratio ref. 1W 98dB ref. rated power 118dB THD (20Hz - 20kHz) <0.03% Bridged Mode Continuous output power into 8 ohm* 200W (23dBW) IHF Dynamic headroom at 8 ohm +6dB IHF dynamic power (maximum short term power per channel) 8 ohm 800W (29dBW) 4 ohm 880W (29.4dBW)

 

 PHYSICAL SPECIFICATIONS Dimensions (W x H x D) 435 x 127 x 385mm Net weight 10kg Shipping weight 12kg Power consumption (120 ~ 240V, 50/60Hz) 390VA * Minimum power per channel, 20Hz - 20kHz, both channels driven with no more than rated distortion. Dimensions are of unit’s cabinet without attached feet; add up to 18mm for total height. Dimension depth excludes terminals, sockets, controls and buttons.

 

 

COME SUONA

 

http://www.audioreview.com/cat/amplification/amplifiers/nad/2400thx/prd_116005_1583crx.aspx

 

 

Home