Di cosa si tratta

Integrato valvolare

Iscrivervi alla newsletter

Produttore

Dared China

Caratteristiche

Pusch pull

 Costo

350 euro    anno 2012  Audiocostruzioni di Sbisa' Giovanni e c snc  Via Grosoli 6  41012  Carpi  MO - tel 059.685054  info@audiocostruzioni.com  e punto vendita

Amplificatore integrato di ingombro contenuto; l’elegante abbinamento del legno laccato nero  con il metallo cromato dello chassis e le dimensioni compatte ne facilitano l’inserimento nell’arredo domestico.

Le finiture sono davvero impressionanti e il rapporto qualità prezzo e favoloso , connettori rca di buona qualità , connettori per diffusori con uscite sia per 4 che 8 ohm .

Come spiegato tante altre volte , non lasciatevi impressionare dalla potenza  di  " soli 16 watt "  credetemi  sono sufficienti per la stragrande maggioranza dei casi.  Il suono e rotondo e avvolgente .  integrato davvero interessante e straordinario se paragonato al costo.

Nel sito sottostante trovate una bellissima e completissima recensione , viene spiegato tutto , anche come regolare il bias .

http://www.6moons.com/audioreviews/dared2/vp16.html

Alcune cose prese dal sito 6moons

Opening up the base panel revealed rationally laid out circuitry optimized for short signal paths. The signal's fed through the gold-plated RCA sockets and carried straight down to the input selector by means of braided/shielded silver wires, then re-directed to the 6SL7 tube sockets. The volume control is a Taiwanese HT brand. The circuit board is now double-sided as opposed to the singled-sided 2003 model published in the importer's AudiogoN advertisement. The four Auricaps remain unchanged but the replacement/addition of some non-inductive cathode resistors by Allen Bradley (USA) and a very large filter capacitor (Japanese Nippon) for the power supply are obvious. The 6L6GT are tuned to a grid bias of -40 volts but the adjustment is handled by a variable resistor. The proper procedure should be done with volume down all the way, no input signal, output loaded (connected to speakers) and with common-sense precaution to avoid electric shock. The 2005 model is slightly more user-friendly because each variable resistor is conveniently coupled with positive and negative probing points on the PCB (the 2003 model required measuring across the resistor). The four adjustment pots are the usual blue mini square. Clockwise equals decrease, anti-clockwise increase. The recommended setting is 0.2 to 0.25 volts DC. If you are seriously considering tube rolling with this amp, be sure to adjust the bias each time you roll. (If I can do it, anybody can.) The difference between the Shuguang/EH readings was as wide as 0.1 volt on my multi-meter.
 

                              E tanto Altro

Home