FM Specifications:
Useable Sensitivity
15dBF which is 1.6uV across 75 ohms 50dB Quieting Sensitivity
Mono: 19dBFwhichis2.5uVacross75ohms
Stereo: 39dBF which is 25uV across 75 ohms
Signal To Noise Ratio Mono: 80dB Stereo: 75dB
Frequency Response Mono: +0,-1dBfrom20to15,000Hz Stereo:
+ 0, - 1dB from 20 to 15,000Hz
Harmonic Distortion
Mono: 0.08%at100Hz 0.08% at 1000Hz 0.12% at 10,000Hz
Stereo: 0.08% at 100Hz 0.08% at 1000Hz 0.12% at 10,000Hz
NOTE: Spectrum analyzer required for accurate measurement of Harmonic
Distortion at 10,000Hz
Intermodulation Distortion Mono, 0.08% Stereo, 0.12% Capture
Ratio 1.5dB
Alternate Channel Selectivity 70dB Spurious Response
100dB
Image Response 80dB Stereo Separation 50dB
AM Specifications:
Sensitivity
AM 20uV external antenna input (50 ohm source input)
Signal To Noise Ratio 50dBat50%modulation 60dB at 100%
modulation
Harmonic Distortion 0.5%maximumat30%modulation
Frequency Response 50Hz to 6000Hz NRSC
NOTE: National Radio Systems Committee proposed spec. for AM tuners, Dec.
1989.
Adjacent Channel Selectivity 45dB minimum IHF Image
Rejection 78dB minimum
General Specifications:
Audio Output
Fixed: 1.2V RMS at 100% modulation Variable: 1.2mV to 1.2V at 100%
modulation
Power Requirements 220 Volts, 50/60Hz at 230 Volts, 50/60Hz at
240 Volts, 50/60Hz at 20 watts.
NOTE: Refer to the rear panel of the MR7084 for the correct voltage
Dimensions 17-1/2 inches (44.5cm) wide, 3-5/8 inches
(9.2cm) high, 17- 1/2 inches (44.5cm) deep, including clearance for
connec- tors. Allow 3/4 inches (1.9cm) in front of the mounting panel for
clearance.
Weight 15 pounds (6.8Kg) net, 27 pounds (12.2Kg) shipping
|